- ページ 4
コントローラー 4IPNET APM100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。4IPNET APM100 20 ページ。 Access point
ページを印刷するFor more information, see the corresponding
chapters:
"AP List" on chapter 3.1
"Add Method – Auto-Provisioning" on
chapter 3.2.3
"WMI Management Access" on chapter 5.2
1.3 Add an Access Point When
Deployed Across Different
Subnets
The other option for cross subnet deployment is
based on CAPWAP tunnel between the APs and
the APM100. It is fine to skip the setup wizard,
but you should confirm whether your default
interface, 192.168.1.10, needs to be modified.
Based on CAPWAP protocol, you may be
required to enter the interface of the access
point and configure the CAPWAP settings
(Home > System > CAPWAP Configuration) by
entering the APM100's IP address. With the
CAPWAP tunnel, the access points deployed
under
NAT
are
communication with the APM100.
Copyright © 2017, 4ipnet, Inc. All rights reserved. All other trademarks mentioned are the property of their respective owners.
still
able
to
establish
APM100 Access Point Controller
This procedure takes about a minute, and this
AP will automatically be added into the AP List
of the APM100. Then, you may apply the
template to fulfill your Wi-Fi requirements.
For more information, see the corresponding
chapters:
"AP List" on chapter 3.1
"Template" on chapter 3.5
"CAPWAP" on chapter 3.9
"WMI Management Access" on chapter 5.2
User Manual ENGLISH
4