- ページ 7

アクセサリー elsner elektronik 70241のPDF 技術仕様と設置手順をオンラインで閲覧またはダウンロードできます。elsner elektronik 70241 9 ページ。 Combined indoor sensor

2.4. Assembly of the sensor

First of all fit the windproof socket with connection. Also seal inlet pipes to avoid

infiltration.

Screw the base plate onto the socket and position the frame of the switching

programme. Connect the CO

terminals provided on the board.

Pin the sensor with the notches on to the metal frame, so that sensor and frame are

fixed.

2.5. Notes on mounting and commissioning

Never expose the device to water (e.g. rain) or dust. This can damage the electronics.

You must not exceed a relative humidity of 95%. Avoid condensation.

After the bus voltage has been applied, the device will enter an initialisation phase

lasting a few seconds. During this phase no information can be received via the bus.

Display and operation of the device

The display can show the current mode with the target temperature. The menue

"Display settings" of the ETS must be set to "Display mode: Temperature control".

Day mode.

Target temperature day is used.

Heating mode.

System is set to heating the

room.

Window open.

When heating, the lower value for frost protection is used as target value,

when cooling, the higher value for heat protection is used as target value.

Heating and coling are blocked by a communication object.

The current target temperature is displayed (not the measured value)!

Indoor Sensor KNX AQS/TH-B-UP • Status: 07.11.2013 • Technical changes reserved. Errors reserved.

Place the CO

sensor unit in the socket. The side with the sensor

membrane must face to front.

Fig. 3

sensor unit and the bus line +/- (black-red plug) to the

Display and operation of the device

Night mode.

Target temperature night is

used.

Cooling mode.

System is set to cool the room.