- ページ 6

照明器具 Dust Free 06168のPDF インストレーション＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。Dust Free 06168 9 ページ。 21", 33", 45" ultraviolet light systems

BIO-FIGHTER® 4XTREME INSTALLATION & OPERATION MANUAL

STRAIGHT-LAMP INSTALLATION

To maximize the efficiency and life of the UV-C

lamp, clean each lamp prior to installation.

Use isopropyl alcohol and cotton cloth to wipe

dust and fingerprints from the lamp.

To install the lamp in its straight-lamp con-

figuration the lower slide bracket must be

removed. After the lower slide bracket has

been removed gently insert lamp into lamp hole

and push upper slide bracket over the retaining

lip of the lamp and tighten the two knurled nuts

until the lamp is securely fastened.

Remove lower slide bracket.

Lamp retaining lip

Fig. 7 After lower slide clip is removed, slip upper slide bracket

over retaining lip of lamp and tighten two knurled nuts.

WARNING

Electrical disconnect required.

Areas where UV fixtures are installed must

have access panel/door disconnect

switches installed. Never view UV-C light

without protective eyewear.

CONNECTING THE HARNESS

(Fig.7 )

After lamp has been installed, attach electrical

harness. The harness connector is asymmetri-

cal and can only be attached one way. If the

harness does not attach easily, rotate 90

degrees and try again.

Fig. 8 Attach electrical harness to lamp.

Upper slide bracket

Close the cover, reinstall the cover retaining

screws, and turn on the electrical service.

Apply included warning label on nearby main-

tenance access panel.

Note: This device uses a cover safety inter-

lock. The cover must be closed for the device

to operate.

The device operates continuously. It is recom-

mended that the device be interlocked with a

power disconnect to prevent inadvertent UV-C

exposure when access panels are removed.

(Fig.8 )