- ページ 5

集塵機 Dust Right SeparatorのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dust Right Separator 8 ページ。

Fig. 1

Fig. 3

Assembly

1. Align arrows in separator canister Top (B) and

Separator Canister Bottom (C) and snap pieces

together to create the full canister. Fig. 1.

2. Insert the five casters (H) into the corresponding

sockets on the bottom of the canister. Fig. 2.

3. Position the lower Chip Separator Ports (G) underneath

the lid with the indents on the Lower Port aligned with

the indents on the lid. Fig. 3. Be sure the Lower Ports

are pointing in opposite directions. Fig. 4. Then

Thread the Upper Chip Separator Port (F) to the

Lower Port (G), sandwiching the lid (A) in between.

4. Secure the Separator Lid (A) to canister by aligning

the lid tab with any one of the 3 tab cutouts in the

Canister's top rim. Rotate clockwise to secure,

reverse to remove. Fig. 5.

5. Thread both hose fittings (E) to either end of the

FlexForm

™

hose (D).

Note: Threading is reversed on these fittings.

6. Insert one end of the FlexForm

Chip Separator Port (G) and the other end into

your shop vacuum. Fig. 6.

Note: Either end can be used as the input or

output ports.

Align

arrows

Triangle

indent

™

hose (E) into

Fig. 2

Fig. 4 - Underside of lid shown

Lid tab

Fig. 5

Fig. 6

Tab cut-out