- ページ 5

フロアマシン Dustbane 50932のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dustbane 50932 8 ページ。 Clean and fast washroom cart

ページを印刷する

Initial Setup (cont.)

The spray attachment is in the accessory box.

Attach it to the discharge hose.

Remove the black cap from the water ﬁ ll port

(it rotates COUNTER CLOCKWISE to open).

Fill the tank with cool, clear tap water. See

Fig. D.

10.

To connect the chemicals, remove the ship-

ping cap and the seal on your chemical bottle

and discard. Place the strainer and weight

into chemical bottle and screw the chemical

feed line cap on to bottle. See Fig. E.

Prime the Unit

Set the nozzle on the spray attachment to "S".

See Fig. F.

Set the chemical select valve to either of the

products (lower two positions on select valve).

See Fig. G.

Turn the power switch on. The pump should run

for a short time, then stop. (The pump will run

until the discharge pressure reaches the factory set

point. The pump will then turn off until the trig-

ger on the spray attachment is activated.)

Direct the spray nozzle into a drain or other con-

tainer and pull the trigger.

Run until a steady spray pattern is established,

without air in the water stream.

Release the trigger. The pump should stop almost

immediately. If it does not, operate the unit lon-

ger as it is not fully primed.

Turn the selector to the other product and repeat.

Fig. D

Water ﬁ ll port

Chemical "A"

Fig. E

Fig. F

Fig. G

Select Valve

Chemical

"B"

Rollover Valve

Chemical "B"

chemical feedline

cap

weight

strainer

Spray attachment

Chemical

"A"