- ページ 7

水システム CB Tech CB-VOCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CB Tech CB-VOC 20 ページ。 Drinking water system

Inspect Your Drinking Water System

Before setting up and connecting your CB-VOC, inspect your DWS to

confirm that it has been received in good condition and that all parts are

included.

The CB-VOC can be installed below the sink or on top of the countertop

next to the sink. Please refer to the Installation Guide included with your

Install Kit for step-by-step instructions.

The CB-VOC can be used inline for connection to refrigerators, water

coolers, or ice makers, so that all of the water from the cold water outlet or

faucet is filtered. CB Tech recommends that a professional plumber install

the system for inline use.

Using a paper towel or cloth, dry off all connections and the system

housing.

Make sure that all connections are tightly secured.

Remove any air and loose carbon from the system.

Allow water to flow through the DWS for 30 minutes. This purges any

air and loose carbon from the system.

Adjust the water supply so that the water flow to the drinking water

faucet does not exceed the flow rate of 0.75 gallons per minute.

NOTE:

It takes approximately 20 seconds to fill a quart at a flow

rate of 0.75 gallons per minute.

Check all connections to make sure that there are no leaks.

Congratulations! Your system is now ready for use!