- ページ 4

室内装飾品 CB2 CROSSROADSのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。CB2 CROSSROADS 4 ページ。 Bookshelf

crossroads

Fit dowels of assembled unit into corresponding

holes of top panel as shown.

wall mounting assembly

For added safety and stability, it is recommended that the wall mounting hardware be

installed. For safe mounting, it is essential to use wall anchors appropriate to your wall

type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs whenever possible.

A) With a 2.5mm (1/16") drill bit, drill two holes to the top of unit. Attach 2 wall

brackets with 2 small screws per bracket as shown.

B) Determine the final location of unit. Mark position on the wall, approximately 2"

below the wall bracket mounted to the back of the unit.

C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall

that is slightly smaller in diameter than the anchor. Gently tap each plastic anchor

until the flange of the anchor is flush with the wall.

D) Attach 2 wall brackets to the wall by inserting 2 large screws through the wall

bracket and into the wall anchor in the wall.

E) Place the unit so the wall bracket on the back edge is aligned with the wall bracket.

F) Lace one end of the wall strap through both brackets, and into the other end of the

strap.

G) Pull the strap tightly until secure.

Repeat step A-G for remaining wall mounting assembly.

Wall mounting assembly is now complete.

NOTE: If you are unsure about your wall type or what mounting method you

should use, consult a qualified professional or your local hardware store.

Made in Vietnam - r09

BOOKSHELF

Customer Service 800.606.6252 | Latest instructions available at www.cb2.com

With assistance of another adult, position

unit upright, while supporting back panels of

assembly. At this point, secure all cams in top

and back panel. Cover all exposed cams with

cam covers.

Assembly is now complete.

WALL

Page 4 of 4