- ページ 4
室内装飾品 CB2 THE WALLのPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。CB2 THE WALL 4 ページ。 Wardrobe
CB2 THE WALL にも： 組み立て説明書 (5 ページ)
ページを印刷するthe wall
For added safety and stability, it is recommended that the wall mounting
hardware be installed. For safe mounting, it is essential to use wall anchors
appropriate to your wall type (i.e. plaster, drywall, concrete, etc.). Mount to
wood studs whenever possible.
NOTE: If you are unsure about your wall type or what mounting
method you should use, consult a qualified professional or your local
hardware store.
A) Attach 2 mounting brackets to top of unit using 2 small screws per
bracket.
B) Determine the final location of unit. Mark position on the wall,
approximately 2" below the mounting bracket mounted to the back of the
unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in
the wall that is slightly smaller in diameter than the anchor. Gently tap the
plastic anchor until the flange of the anchor is flush with the wall.
D) Attach 2 mounting brackets to the wall by inserting 2 large screws
through each mounting bracket and into the wall anchor.
E) Place the unit so the mounting brackets on the back edge are aligned
with the wall brackets.
F) Lace one end of each wall strap through brackets, and into the other
end of the strap.
G) Pull the strap tightly until secure.
Wall mounting assembly is now complete.
hinge adjustment
If the doors do not appear square or aligned, loosen or tighten the appropriate screws on each case hinge as
illustrated.
1
A
B
Side to side adjustment:
Loosen screw A, adjust gap with
screw B and re-tighten screw A
Made in Vietnam - r02
BATH CABINET
2
A
B
Depth adjustment:
Loosen screw A, push hinge arm
forwards or backwards, re-tighten
screw A and secure screw B with
a 1/4 turn clockwise
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
D
C
F
3
A
B
Height adjustment:
Loosen screw A & B, adjust door
height and re-tighten screws A&B
A
Page 4 of 4