- ページ 3

アクセサリー CBA RA-4961-MCQのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CBA RA-4961-MCQ 4 ページ。 Wireless magnetic contact

Installation:

1. Select the location where the magnetic contact and magnet will be mounted. The magnet may

be installed on either side of the contact, but the alignment marks should be aligned with the

marks on the contact. The gap should be no more than

2. Use the included adhesive strips to mount the door contact and magnet.

Programming the Contact Notification Mode:

1. The magnetic contact has three modes— Remote Alarm, OFF, and Local and Remote Alarm.

2. When the switch is flipped to Remote Alarm, when the magnetic contact is triggered, the status

LED will switch on and there will be no sound from the contact. The receiver will operate as

programmed.

3. When the switch is flipped to OFF, the magnetic contact will not function.

4. When the switch is flipped to Local and Remote Alarm, when the door contact is triggered, the

built-in speaker will sound for 15 seconds or until the unit is switched to OFF. The receiver will

operate as programmed.

Pairing the Contact:

1. Follow the pairing instructions for the RA-4961-K1Q receiver or RA-4961-VPQ wireless receiver

to enter the pairing mode (Refer to the RA-4961-K1Q or RA-4961-VPQ manual for detailed

instructions).

2. Switch the contact to either of the two operating modes.

3. Trigger the contact by moving the magnet away from the contact or by opening the door/window

if already mounted.

4. The receiver will beep once and cycle to the next channel to

confirm successful pairing.

SECO-LARM U.S.A., Inc.

Remote

Alarm

OFF

CBA Wireless Magnetic Contact

"(1cm).

Local and

Remote

Alarm