ページを印刷するTroubleshooting
Check the following points if a problem occurs while the monitor is in use. Contact your vendor if
the problem persists.
Symptoms
Image does not appear
The image is either dim or
completely white.
Screen color is indistinct, or
there is no color.
The image is indistinct, rolls
over on the LCD, is cut off
or superimposed.
The batteries are hot.
Likely cause
●
Is the power indicator lit?
●
Is the camera connected
to the video input terminal
(VIDEO)?
●
Is the AC adapter set up cor-
rectly?
●
Have the batteries run down? Replace the batteries.
●
Are the batteries inserted in
the right orientation (+/-).
●
Is the lens cover still on the
camera?
●
Is the camera switched off?
●
Is the signal type (NTSC /
PAL) correct?
●
Is the brightness adjusted
correctly?
●
Is the 75Ω terminator switch
(75Ω) set to the right posi-
tion?
●
Is the 75Ω terminator switch
(75Ω) set to the right posi-
tion?
●
Is the signal type (NTSC /
PAL) correct?
●
Is the power indicator blink-
ing?
●
Is the signal type (NTSC /
PAL) correct?
●
Have the batteries run down?
(older batteries may generate
more heat, but that does not
indicate a malfunction)
14
Action
Check the power switch.
Connect the coaxial cable correctly.
Check the connections between
the monitor AC adapter connec-
tion terminal and the DC plug, and
between the AC adapter and the
electrical outlet.
Insert the batteries with the right
polarity.
Take the lens cover off.
Switch the camera on.
Check the signal type in the region
where you are using the monitor.
Use the brightness adjustment dial
to adjust brightness.
Set it to the right position.
Set it to the right position.
Check the signal type in the region
where you are using the monitor.
Replace the batteries. Alternatively,
use the AC adapter.
Check the signal type in the region
where you are using the monitor.
Replace the batteries.