- ページ 2

PDA Datalogic Skorpio X5のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Datalogic Skorpio X5 2 ページ。 4 slot battery charger
Datalogic Skorpio X5 にも：クイック・スタート・マニュアル (8 ページ), クイック・スタート・マニュアル (2 ページ)

ページを印刷する

BATTERY INSTALLATION

1. Attach the handstrap to the eyelet as shown.

2. Insert the handstrap lower bridge into the hand strap.

3. Attach the handstrap lower bridge to the battery pack.

4. Insert the battery pack into the slot, top first, and press it into place until it clicks.

CHARGING INSTRUCTIONS

The battery pack is not initially fully charged. After installing the battery, charge it with the Datalo-

gic USB Type-C wall adapter or with a dock.

During the charging process the charging LED positioned at the top left side of the display glows

orange constantly. Once the charging process has been completed, the charging LED glows green

constantly.

Charge with USB

Use the Skorpio X5 USB-type C wall adapter (available as an accessory, p/n 91ACC0048) to charge

the device from a power outlet.

You can also use the supplied Type-A/Type-C cable to charge the Skorpio X5 from any self-powe-

red USB hub or USB port on a computer.

Charge with the Optional Dock

Insert the device into the dock with the screen facing front and the head facing up.

CAUTION: Use only a Datalogic approved power supply to power any of the docks.

Do not put any foreign object such as, but not limited to, coins, paper clips, stickers inside

the slot of any of the wireless charging docks.

Do not apply any sticker to the Skorpio X5 (see the examples below).

Foreign objects could overheat.

No Clip

No Coin

No Sticker

CAUTION: Keep the wireless logo area free. Do not place stickers or write on the logo

surface area.

NOTE: The Skorpio X5 may get warm during charging. This is normal and does not

mean a malfunction. For information on the docks, refer to the Quick Start Guide

included in the dock's box.

INSTALL THE SD CARD

NOTE: The Skorpio X5 supports microSD card up to UHS-1 (104 MB/s bus speed).

Contact the sales support team to select the memory card for your device.

1. Remove the battery pack.

2. Remove the microSD card slot cover.

3. Slide the cardholder to the right and then pull it up.

4. Insert the microSD card into the cardholder; push the cardholder down and then sliding it to

the left.

5. Replace the microSD card slot cover.

6. Replace the battery pack.

SCANNING AND IMAGING

To scan a bar code symbol:

1. Point the scan window at the bar code.

2. Press one of the scan triggers. The imager projects a laser aiming pattern that is used to

position the barcode or object within the field of view.

3. Center the symbol in any orientation within the aiming pattern. Ensure the entire symbol is

within the rectangular area formed by the brackets in the aiming pattern, then either wait for

the timeout or release the Scan Key to capture the image. A red beam illuminates the symbol,

which is captured and decoded.

If the scan has been successful:

y If enabled, the good read beep plays.

y If enabled, the GreenSpot projects a green spot onto the bar code image.

y If enabled, the good read indicator positioned at the top left side of the display glows solid

green.

Linear Bar Code

Relative Size and Location of Aiming System Pattern