- ページ 4
コントロールパネル CBE Avida PC220-KTのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CBE Avida PC220-KT 16 ページ。
ページを印刷する
MAIN PARTS OF THE ELECTRICAL SYSTEM
ADVICE AND CHECKS
GB
GB
4
CONTROL PANEL "PC220-KT"
12V DISTRIBUTION BOX "DS520-AN"
relays, pump relays, car battery recharging device, ampere meter, protection fuses.
BATTERY CHARGER
- supplies charge to batteries.
ELECTRONIC TANK PROBE
visualization in %.
LEISURE BATTERY "B2"
CHASSIS BATTERY "B1"
ENGINE ALTERNATOR
240V CIRCUIT BREAKER
"50A" CHASSIS (B1) AND LEISURE (B2) BATTERY PROTECTION FUSES.
IMPORTANT: Maintenance on the electric equipment must be carried out by a qualified
technician. Before carrying out maintenance, disconnect the battery and the 240V mains
power supply.
BATTERIES
Read with care the instructions of use and maintenance of the batteries.
The acid kept in the batteries is poisonous and corrosive. Avoid any contact with skin and eyes.
If the battery is completely discharged it needs recharging for up to 10 hours. If discharged for more
than 8 weeks it may be damaged.
Check periodically the level of the liquid of the battery (with acid); the GEL battery does not need any
maintenance but does require countinuous recharging.
Check the correct tightening of the terminal connection binding screw and ensure terminals are
clean.
If the leisure battery is removed, isolate the positive pole (in order to avoid a short circuit during an
accidental car engine starting).
In case of a prolonged period, all batteries should be disconnected or recharged regularly.
BATTERY CHARGER
The battery charger must be installed in a dry and ventilated place.
The installation of this device must be carried out by a qualified technician.
In case of battery charger's misuse, the guarantee is void and the manufacturer declines all
responsibility for damages to people and property.
Do not carry out any maintenance when the battery charger is connected to the 240V mains power
supply. Do not cover air vents, the charger requires appropriate ventilation.
Before disconnecting the battery charger from 240V mains power supply, turn the circuit breaker off.
TANK PROBES
Never leave water in the tanks for a prolonged period of time, in order to avoid fouling, especially in
the waste water tank.
240V CIRCUIT BREAKER
IMPORTANT: maintenance on the electric equipment must be carried out by a qualified technician.
Before carrying out maintenance, disconnect the battery and the 240V mains power supply.
Before taking off the cover, check that the 240V mains power supply is disconnected.
In order to avoid damage to the circuit breaker, check that the connections are tightened correctly.
In order to turn the power off to the whole 240V system, please ensure that the 240V main circuit
breaker is in the (OFF) position.
Connect and disconnect the external 240V power supply only when the main switch is off.
If the circuit breaker trips, ensure to find the problem before turning the power back on.
FUSES
Replace the fuses after finding out the real cause of the damage only.
When the fuses are replaced inspect the value of the amperage established.
- mains' control, battery test, tank test and clock function.
- main relays, battery parallel relays (12V - 70A), fridge
- it measures the content of the fresh and waste water tanks,
- it gives power to all users.
- chassis power.
- it recharges in parallel both the chassis and the leisure battery.
- it switches power and protects all users.