ページを印刷するPSU's consist of long-life industrial Meanwell SMPS's which run more quietly and efficient
then linear PSU's.
When this device is used in passive mode, so input without active gain, no mid/side and no
gain compensation on the output, it's 100% passive and only relay-contacts are inline. This
means it's basically a straight wire.
Pushswitch labeling:
To have some extra visual feedback on the push-switches you can put labels under the
switch-covers. You can simply, but carefully, remove the switch cover with a small
screwdriver and put something like a transparent dymo letratag sticker on the white plastic
piece inside the switch-cover.
Specifications:
Some real-world measurement figures done with RMAA on a Lynx Hilo at 24bit 96khz.
When doing the measurements, the inserts where not activated. The inserts themselves
hardly add noise or distortion by itself because the only difference is that it will be send to
the DB25 connector instead.
straight
Lynx Hilo @
cable
2496 with
(cable
no cables
directly
on inserts
from
DA/AD)
Noise level,
-119.3
dB (A):
Dynamic
119.3
range, dB
(A):
THD, %:
0.0005
IMD +
0.0007
Noise, %:
Stereo
crosstalk,
-116.7
dB:
Input voltage 100 to 240VAC 50/60HZ.
Power consumption minimum 5 watt
Power consumption maximum 30 watt
(Power consumption depends on the amount of inserts, input, output etc activated)
Unit size: standard 2u 19 inch, depth 25cm
Weight: approx 4kg
Specifications subject to change because always improving
passive
active
mode
gain on
(input to
(active
output in
input on
passive
set to 0)
mode)
-119.3
-116.5
119.3
116.4
0.0005
0.0006
0.0007
0.0008
-104.3
-92.9
© DuTCH.audio 2018
Handmade in Holland on Solarpower
https://dutch.audio
Phone: +31 6 53998686
MS + width
bypass
on
gain comp
(MS enabled
on
and width
(output byp
set to 0)
comp set to
0)
-115.8
-115.2
115.8
115.2
0.0006
0.0006
0.0009
0.0010
-61.8
-105.6
active gain
MS and
width on
(input gain at
0, MS and
width on)
-114.1
114.0
0.0007
0.0012
-61.6