- ページ 3

ストレージ Dataman Vali-FlashのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dataman Vali-Flash 13 ページ。

1. To use the USB CompactFlash card reader to validate your devices, please install

the Memorex CompactFlash card reader and the drivers from the CD-ROM.

2. Once you have installed your CompactFlash™ reader and it's accompanying

drivers, you can proceed with the installation of the Vali-Flash software.

3. To install the Vali-Flash software, follow the normal installation procedure used

for all Windows based programs. The installation program should automatically

launch when the CD-ROM is inserted in your CD drive. If for any reason it does

not, then simply RUN "setup.exe" from the CD-ROM.

NOTE: Please make sure you follow the proper Windows operating system

procedures for ejecting hardware when disconnecting the CompactFlash card

reader. Failure to eject or stop the card reader device prior to removing it may

cause the Vali-Flash program to hang or incorrectly read the CompactFlash™

memory. This is only applicable to removing the card reader and not necessarily

the CompactFlash memory unless you are using a PCMCIA card reader.

Dataman Vali-Flash User Manual

INSTALLATION

Page 3 of 13