- ページ 2
おもちゃ 4M Green Science 00-03448のPDF 使用方法をオンラインで閲覧またはダウンロードできます。4M Green Science 00-03448 2 ページ。 Hybrid crabot
D. INSTRUCTIONS
1
1
E
E
D
D
3
3
C
C
5
5
1. Slide the solar panel (part E) onto the solar panel holder (part D). Make sure the +/- connections on the bottom of the solar panel line
up with the markings on the base as shown.
2. Insert the red wire into the positive terminal and the blue wire into the negative terminal. Secure in place with a screw (part V).
3. Clip the solar panel holder onto the top joint of the support arm (part U). Clip the support arm onto the battery holder (part C).
4. Install the motor (part G) in the robot body (part A). Add the motor cover (part B) and secure it with a screw.
5. Slot the battery holder into the top of the main body.
6. Insert the bare ends of both black wires into the left-hand terminal and secure them with a terminal cap (part T). Repeat with the three
red wires in the centre terminal and the two blue wires in the right-hand terminal.
2
2
V
V
T
T
4
4
B
B
G
G
U
U
6
6
W
W
7
7
9
9
I
I
J
J
N
N
K
K
11
11
7. Check your robot against the diagram to make sure your connections are correct.
8. Assemble a right leg as shown. Slot together a right leg (part H), a right linkage (part O), long linkage (part I) and short linkage (part J).
Add three pegs (part R) to secure the joints. Repeat this step to make another leg for the back.
9. Assemble a left leg as shown. Slot together a left leg (part K), a left linkage (part N), long linkage and short linkage. Add three pegs to
secure the joints. Repeat this step to make another leg for the back.
10. Clip one of the assembled left legs onto the front of the robot body and secure it with three pegs.
11. Clip one of the assembled right legs onto the front of the robot body and secure it with three pegs.
12. Repeat step 11 and 12 to attach the remaining two legs to the back of the body.
QUESTION AND COMMENTS
We treasure you as a customer and your satisfaction with this product is important to us. In case you have any comments or questions, or you find any
parts of this kit missing or defective, please do not hesitate to contact our distributor in your country, whose address is printed on the package. You are
also welcome to contact our marketing support team at Email: [email protected], Fax (852) 25911566, Tel (852) 28936241, Web site: WWW.4M-
IND.COM
8
8
I
I
O
O
R
R
H
H
10
10
x2
x2
12
12
©2021 4M INDUSTRIAL DEVELOPMENT LIMITED. ALL RIGHTS RESERVED.
J
J
x2
x2