- ページ 4

プリンター Datamax M-Class Mark IIのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Datamax M-Class Mark II 6 ページ。 Rfid option
Datamax M-Class Mark II にも：マニュアル (8 ページ), クイック・スタート・マニュアル (4 ページ), マニュアル (10 ページ), クイック・スタート・マニュアル (8 ページ), クイック・スタート・マニュアル (6 ページ), クイック・スタート・マニュアル (8 ページ)

Step 2: Installing the Cutter

 Position the Cutter for mounting on the front of

the printer.

 Tighten the Mounting Screw to secure the

mechanism to the printer.

This completes the installation process.

Proceed to Loading Media.

Before proceeding, ensure that the free end of the media has a clean, straight edge.

 Route the media through the printer (see the

Operator's Manual for more information) and then

out through the Cutter's Opening, as shown. Close

and latch the printhead mechanism.

 Close the cover.

 Plug in and turn 'On' the printer.

 Press the FEED Button to align the label's position.

The Cutter is plug and play; no setup or configuration is necessary. When the power is applied, the Cutter

blade will cycle, indicating that the printer has automatically sensed and enabled the Cutter for operation.

 Note: The operation of the Cutter is also controlled via software commands from the host. Be sure that your

software program is properly configured for the cutter and the desired label size.

Cutter

Mounting Screw

Opening