- ページ 6

ラベルメーカー Datamax H-ClassのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Datamax H-Class 12 ページ。 Cutter option
Datamax H-Class にも：マニュアル (8 ページ), クイック・スタート・マニュアル (12 ページ), マニュアル (14 ページ), マニュアル (10 ページ)

2) Close the cover then plug the power cord

into the AC Receptacle and turn ON the

Power Switch.

3) Press the FEED Key on the Front

Panel, and then proceed accordingly:



If cutting standard size labels and a

cut was performed, this completes

installation; or,



If a cut was not performed, see

"Configuring the Printer," below.

 Note: If cutting small labels,

performance may be increased; see

"Increasing Small Label Throughput,"

below.

Configuring the Printer

The Cutter, a plug and play option, may require configuration if the default setup has changed:

 Note:

The Cutter can also be controlled by host software commands. Ensure that your labeling

program is properly set to cut, including the desired label size. To test the Cutter, see

"Testing the Cutter"; or, if problems occur, see "Troubleshooting" (below).

Press the MENU Key on the printer's front panel. (See the Operator's Manual for menu details.)

Using the DOWN ARROW Key, scroll to PRINTER OPTIONS then press the ENTER Key.

Using the DOWN ARROW Key, scroll to CUTTER then press the ENTER Key.

Using the DOWN ARROW Key, scroll to AUTO then press the ENTER Key.

Press the ESCAPE Key and then, at the SAVE CHANGES? prompt, select YES.

Turn the Power Switch OFF and ON to complete configuration.

Front Panel

FEED

Key

Power Switch

AC Receptacle