- ページ 4

スキャナー Datamax I-ClassのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Datamax I-Class 15 ページ。 Present sensor option
Datamax I-Class にも：クイック・スタート・マニュアル (4 ページ), クイック・スタート・マニュアル (6 ページ)

ページを印刷する

Setup and Configuration

The Scanner is setup at the factory to read the bar codes on most labels. And, in most cases, further setup

will not be required.

However, if you need to modify the setup to meet your application, this section details the operational

settings of the unit.

To access these menu items, use the printer's front panel, enter 'MENU MODE' and go to 'PRINTER

OPTIONS'  'SCANNER' (see the I-Class Operator's Manual for menu system navigation details).



'MODE'

is used for Scanner detection. The settings have differing functions, as follows:

Enabled

– Upon power-up, the printer will attempt to detect the Scanner. If not detected, a

"Scanner Fault" occurs.

Disabled – Upon power-up, the printer will not attempt to detect the Scanner. No scanning will

occur.

Auto

– Upon power-up, the printer will attempt to detect the Scanner. If detected, the printer

will function normally with the scanning function.



'BARCODES'

is used to enable the reading of a particular bar code symbology. The default setting

enables the reading of all bar codes, except IATA. The table below lists the supported symbologies.

Code 39

UPC-A

UPC-E

Interleaved 2 of 5 (I2 of 5)

Code 128

EAN-13

EAN-8

HBIC

Codabar

Interleaved 2 of 5 with a modulo 10 checksum

Interleaved 2 of 5 with modulo 10 checksum & bearer bars

IATA

Plessey

2 digit UPC addendum

5 digit UPC addendum

Code 93

UCC/EAN 128

UCC/EAN 128 K-Mart non-EDI

UCC/EAN 128 Random Weight

[1]

Readable only when using the 'Barcode Count' menu parameter (see below).

Symbology

Linear Scanner Supported



[1]



[1]

