- ページ 6

コントローラー Datapath VSN982のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Datapath VSN982 20 ページ。 Wall controller
Datapath VSN982 にも：クイック・スタート・マニュアル (15 ページ)

STEP 6 POWERING UP THE SYSTEM

VSN wall controllers are supplied with either a Redundant Power Supply Unit (RPSU)

or an ATX power supply. An RPSU power supply requires two power cables and an

ATX supply requires one power cable. All power cables are supplied with your VSN

wall controller.

1. Connect power cable(s) to the VSN wall controller then plug into a mains supply.

2. Switch on the power supply units.

RPSU Power Switch

3. Switch on the system using the power button on the front panel.

Note:

If you have a VSN Expansion Chassis connected to the main unit (Step 2), the power

supply units on the expansion chassis should be switched on prior to the main VSN

wall controller. There is no requirement to switch on the expansion chassis on the

front panel (3).

Page 6

ATX Power Switch