- ページ 4

スイッチ Dataprobe 4P-MASのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dataprobe 4P-MAS 9 ページ。 4 position menu activated switch

Model 4P-MAS-30

Password

To change the password, it must be reentered. Then a prompt for a new password, then a confirmation

of the new password. The password may be up to eight characters and is case sensitive.

ENTER NEW PASSWORD > TEST

RE-ENTER NEW PASSWORD > TEST

PASSWORD CHANGED

Please remember you password. If you forget your password, the unit needs to be returned to

Dataprobe for re-initialization. There is a charge for this.

Set Baud Rate

ENTER BAUD =>

Valid selections are 300 600 1200 2400 4800 9600 19200 38400 57600 and 115200

This changes only the default speed. The Auto Rate Detector can always be invoked by sending the

Enter Key several times.

Set Character Format

ENTER N,E,O >

Enter only the Parity, N, E or O for None, Even, Odd respectively. The 4P-MAS will automatically

adjust for the number of data bits and 1 stop bit.

Set Lead Control

ENTER Y/N >

Enter Y to add RTS/DTR Lead control to the 4P-MAS. This mode allows the RTS or DTR of Ports A

through D to select the Master Port. Change this setting to Yes if you require one or more of the

devices connected to ports A through D to be able to dial out through the modem on the Master Port.

See page 5 for a detailed description of Lead control.

Mode

Sets the 4P-MAS for either Terminal or Modem use. Each time selection 6 is chosen, this setting

toggles.

Terminal Mode:

Port. This mode allows an unlimited number of login attempts. Use this mode for direct

cable connections from a PC or Terminal to the 4P-MAS.

Modem Mode:

DCD goes high (indicating that a call has been established) the 4P-MAS generates the

modem. Use this setting when the 4P-MAS is connected to a dial modem.

The 4P-MAS does not monitor the connection status of the Master

The 4P-MAS monitors the DCD lead from the Master Port. Each time

Page 4