- ページ 9

スイッチ Dataprobe iBootのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dataprobe iBoot 20 ページ。 Web enabled remote power control
Dataprobe iBoot にも：取扱説明書 (16 ページ)

iBoot Ver 1.5

Page 9

iBoot Configuration

Setting I/P Address

Consult your Network Administrator to determine the appropriate

IP address. The IP address can be set in any of four ways:

1. Automatically from a DHCP Server

2. Web Browser via the Set-up Page

3. ibootrst.exe Program from Dataprobe

4. ARP / Ping

iBoot comes with factory installed IP address 192.168.1.254.

and ready to accept a new IP address from a DHCP Server. If

you network has a DHCP server, it will automatically assign an

IP address to iBoot the first time it is connected and powered up.

1. Setting the IP address from a DHCP Server

A DHCP server will automatically assign an IP address (dynamic

address) as well as Subnet Mask and Gateway to the iBoot. If

you power up iBoot without a fixed (static) IP address, the DHCP

server will be able to assign an IP address. This is the factory

default setting for iBoot. Once an IP address is assigned, you

must check the DHCP server to see what address is assigned to

iBoot.

If you set the IP address using another method, the address

becomes static. To return iBoot to dynamic addressing using

DHCP, change the IP address, using the web browser to 0.0.0.0

2. Setting the IP address using Web Browser

To set the IP address using a Web Browser, connect the

10/100Base-T connection to your local ethernet network and

apply power to iBoot.

Open your browser and access iBoot by entering the default

(192.168.1.254) or current IP address into your browser's

Address window. Enter the password (the factory default is

PASS). Click on Setup and follow the instructions on Page 14.