- ページ 3

スイッチ Dataprobe IP-2810のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dataprobe IP-2810 13 ページ。 Dual input web controlled power switches

iP-28xx

Hardware Installation

Important Note: Make all communications connection prior to applying power. To change communications cables, remove

power or power cycle the unit after connections.

J2 - 10baseT Connector

The 10baseT connector is located on the rear panel of the switch. It provides connection to the Ethernet.

Note: Connection to an Ethernet hub is made using the cable provided. To directly connect to a PC, a crossover

cable is required. This cable is available at any computer store.

An LED on the jack indicates when the connection to the network is properly established

J1 - Serial Connection * for models without internal modem *

This connection provides for RS-232 connection for out-of-band connection to the switch. A terminal or modem can be

attached directly to this 9 pin connector. With a modem attached, connection is made using PPP (Dial-up-Networking) and

Telnet.

Connection directly to a laptop or terminal requires a null modem (crossover) cable.

With a terminal directly installed, a simple menu interface is used. These menus are identical to the telnet setup and control

screens. Use any terminal emulation software to connect to the switch.

Connection parameters are: 19200bps, 8 data bits, 1 stop bit, no parity (19200,8,n,1). Set flow control to OFF.

Page 3

Model iP-2815

2 NEMA 5-15 Linecords

8 NEMA 515 Outlets

J1-Serial J2-Network

Model iP-2815-M

2 NEMA 5-15 Linecords

8 NEMA 515 Outlets

J1-Phone Line* J2-Network

Model iP-2820

2 NEMA 5-15 Linecords

8 NEMA 515 Outlets

J1-Serial J2-Network

Model iP-2820-M

2 NEMA 5-20 Linecords

8 NEMA 515 Outlets

J1-Phone Line* J2-Network

Model iP-2810

2 IEC320 Inputs

8 IEC320 Outlets

J1-Serial J2-Network

Model iP-2810-M

2 IEC320 Inputs

8 IEC320 Outlets

J1-Phone Line* J2-Network

* RJ11 to D9 Adaptor

Item 1490149 Included

with all Modem models