ページを印刷するQuick Reference Guide
Fluid Connection
Fluid Control Knob
Trigger Housing
Mounting bolt
Figure 1
Installation
Mounting
When using the supplied mounting bolt, install the
spray gun onto a mounting rod 1/2" and tighten
using the hex screw. The mounting bolt can be
attached to either side of the spray gun by simply
unscrewing the bolt and reversing position.
Fittings
The DUX Automatic spray gun uses push-lock
style fittings as standard equipment. To attach the
hoses, insert one end of the hose into the fitting
until it's locked it into place. To release the lock,
push the plastic locking ring toward the fitting
while removing the hose (See Figure 2).
Figure 2
For customer service call 888.389.2732
Triggering Air
Setup
Prior to setting up air and fluid hose(s) please
note:
•
All hoses must be cut clean and straight
without deformity for proper fit.
•
Use an air filter to ensure a clean, dry
air supply.
•
Triggering air, atomizing air and fan
control air (when applicable) must be
supplied and regulated separately.
•
The fluid hose must have a regulator,
shut-off valve, and a filter prior to use.
Connections
Attach the triggering air, atomizing air, and fluid
hoses to the corresponding connections on the
spray gun. When applicable also attach the fan
control air.
NOTE: When using fittings other than the
supplied push-lock style fittings, installation may
differ.
AUTOMATIC
Fan Control
(Automatic model shown)*
Air Cap
Fluid Tip
Atomizing Air
*See figure 4 on
page 5 for manual
fan control
!
Page 4