- ページ 16

録音機器 4ms SamplerのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。4ms Sampler 20 ページ。

[AUTO STOP ON SAMPLE CHANGE]
Possible values: Yes, No, Looping Only
Default value: Yes
Yes: changing to a new sample always stops/restarts playback
No: changing to a new sample never interrupts playback
Looping Only: changing to a new sample restarts playback only when looping
[PLAY BUTTON STOPS WITH LENGTH AT FULL]
Possible values: Yes, No
Default value: Yes
Yes: Play buttons act as start/re-start, unless Length is at 100%, then they act as start/stop
No: Play buttons always act as start/re-start sample
[QUANTIZE CHANNEL 1 1V/OCT JACK]
Possible values: Yes, No
Default value: No
Whether or not the Pitch CV jack is quantized to semitones
[QUANTIZE CHANNEL 2 1V/OCT JACK]
Not used on the Sampler
[SHORT SAMPLE PERCUSSIVE ENVELOPE]
Not used on the Sampler. Percussive envelopes can be disabled by setting FADE TIME to 0.
[CROSSFADE SAMPLE END POINTS]
Not used on the Sampler. Crossfading can be disabled by settings FADE TIME to 0 (see below).
[STARTUP BANK CHANNEL 1]
Possible values: any number from 0 to 59, specifying which bank to jump to when powering up.
The ones digit of the bank number equals color of the bank, with 0 = White, 1 = Red, ... 9 = Pearl.
The tens digit of the bank number equals the number of blinks (ranging from 0 to 5).
Therefore 3 means Yellow (no blinks), and 41 means Red-4 (four blinks).
[STARTUP BANK CHANNEL 2]
Not used on Sampler
[TRIG DELAY]
Possible values: any whole number between 1 and 20, which sets the trigger delay in milliseconds.
Default: 8 (which is 8ms).
This is the amount of delay automatically added after a trigger is received on the Play/Rec trigger
jack, before the Pitch CV and Start Pos CV jacks are read and the sample is played. This delay allows
the Sampler to work with sequencers and keyboards which output a gate before the CV stabilizes at a
voltage.
[FADE TIME]
Possible values: any number between 0 and 255 which translates to a fade time in milliseconds. The
value of 0 means no crossfading will happen.
Default: 24 (which is 24ms).
See the section Adjustable Fade Time on page 15 for an explanation of this feature.
This value can also be controlled on the Sampler by holding Reverse and turning Length.
[AUTO INCREMENT REC SLOT ON TRIG]
Not used on the Sampler (future firmware version will support it).
Page
16
of
20