- ページ 7

マイクロコントローラ 4ms Quad Clock Distributor ExpanderのPDF ビルダーズマニュアルをオンラインで閲覧またはダウンロードできます。4ms Quad Clock Distributor Expander 12 ページ。

Step 8: Mounting part 1

A. Remove plastic wrap from panel.

B. Push the LEDs down close to the PCB. Take the panel and

gently lower it down on the PCB. Wiggle it slightly so that it

fits over the pot shafts, then the jacks.

C. Once the panel is on, hold everything together with one hand

while putting a nut on the corner jacks and potentiometers with

the other hand. This is tricky and you may drop the nut a few

times: don't worry, this is the hardest part. Tighten the nuts down

slightly (1/8 turn) with a 5/16" (jacks), 3/8" (pots), and 1/4"

(switches) socket or pliers (be careful not the scratch the panel!).

D. Flip it over and make sure there are

no gaps between the jack and the PCB

(see photo). Also, make sure the PCB

is as close to parallel with the panel as

possible. Now, install the rest of the

nuts on the jacks, potentiometers, and

switches. You can go slightly tighter

than the 1/8 turn to get the panel to fit

snug, now that we've verified the

hardware is sitting flush to the PCB.

The tension will keep the board and

panel together. Be careful to only hold by the base (either direction when holding) or the two pieces will

come apart.

Above: Step 8D Install the remaining hardware on the panel. When you flip the module over before

soldering, be careful the two parts stay together. Place against a hard surface or in a vise.