- ページ 6
体重計 ADE M10010のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ADE M10010 12 ページ。 Electronic baby scale, class iii approved
Tare function
This function enables the user to weigh the baby together with other objects (e.g. diaper, vetst, towel
or blanket) without getting any other result than just the baby's weight.
-
Start the scale by using the tilting switch underneath the base right hand side.
-
Zero the scale by pressing the Zero key if necessary. The zero indicator will be seen on the
display.
-
Place object (e.g. diaper, vest, towel or blanket) on the tray.
-
Press Tare key to come back to zero. Display should show `0.00´. The display will show the
tare indicator.
-
Place the baby on the tray.
-
The weight displayed is just baby's weight.
If the tarred objects remain always the same you may continue weighing another baby and the scale
will only show the weight of the baby you are weighing. Once the scale is shut off (e.g. automatically in
battery operating mode) the stored value is cleared. If the tare value is changing during operation of
the scale, complete unloading of the scale is necessary. Additionally press zero key to return to
normal status.
Hold function
Press the Hold key in case of unstable readout which might occur if for example the baby is constantly
moving on the baby tray. The scale will hold the result displayed. After scale has been unloaded, the
result value is still readable and can be noted. This allows taking care of the baby first.
Press Hold key again to return to normal status.
Unit function
By using the Unit key you may select the weighing mode (kg, lb).
Before weighing always make sure you are in the selected weighing mode.
Cleaning
Before cleaning make sure the scale has been disconnected from the socket.
For cleaning just use a damp cloth or common disinfection products.
Do not use any aggressive cleaning fluids.
Make sure no water or cleaning fluid penetrates the scale.
Service
Display indication
Safety instructions
Do NOT use the scale
•
If the mains adapter shows visible damages
•
If mains adapter is not working properly
•
After long storage in humid places
5
Cleaning, Maintenance and Re-approval
Recharge the power-pack by using the mains adapter. (see also page 3
chapter Power Supply of the scale)
Any other failure messages on the display e.g. Err 4, Err 5, Err 6 or Err 9
please contact your local dealer or service partner or see Service Manual
where instructions for authorized technical staff is available.
050100-Rev000-M10010