- ページ 3
自動車アクセサリー DV8 Inner FenderのPDF インストール方法をオンラインで閲覧またはダウンロードできます。DV8 Inner Fender 5 ページ。
ページを印刷する
5) You will secure the arm with the sup-
plied longer stainless screw thru the
hole in the liner. Tighten the arm while
holding it in place. The arm will be at
an angle. You can let go of the arm
when it is tight enough for it not to
drop down. Tighten enough to hold lin-
er secure.
6) Now you can install the front half.
(part that has the DV8 cut out of it) Place
the liner in bottom first just behind the
spring perch. Secure it loosely with the
factory bolts. Up top two bolts and front
fender spot. (Wire the second light up
through the engine bay at this time. )
7)
Next step is aligning the two halves.
To do so push back on the two halves un-
til the holes line up to screw in the two
stainless short screws. Once those two
screws are in and tight, you can fully se-
cure the front section.
8) Repeat these steps on the opposite
side. Once you have the inner fenders
secure proceed to step 9.
9) Connect all of the cables to the wa-
terproof receivers and screw them in
until they are secure. (The order of the
wires does not matter)