Step 3.
Make sure the tool jaws are
centralised over the crimp
ring at 90° to the joint.
When using the manual tool,
close the tool completely to
compress the crimp ring.
The tool will click at final
compression.
When using a battery tool, ensure the tool has fully closed
and released indicating a completed joint.
Step 4.
For
manual
regularly check with the
gauge supplied by sliding
the opening of the gauge
over the compressed ring. If
the gauge passes over all
parts of the ring without
interference,
joint has been crimped
satisfactorily.
Correctly serviced battery
tool do not require a gauge
check
if
the
been completed as per
instructions.
32mm Joints
When
crimping
32mm, use the battery
tool with a 32mm DuoPEX
Jaw. Place the fitting inside
the jaws so that the raised
section of the plastic sight
ring fits into the slot in the
jaws. Release the jaws so
they fit snugly over the
fitting, ensuring that the
raised section of the plastic
sight ring is still located in
the slots in the jaw.
Press the switch mechanism until the joint is completed.
Press the back end of the jaws and remove the
completed joint.
tool
use,
then
the
joint
has
Auspex
If the gauge experiences
any
interference,
joint is under crimped.
The tool should then
be
adjusted.
adjustment instructions
in
this
Do not double crimp.
Auspex Fire Manual
the
(See
manual).
|
9