- ページ 13

グリル Aussie Vantage 2200のPDF 組立・使用マニュアルをオンラインで閲覧またはダウンロードできます。Aussie Vantage 2200 16 ページ。 Portable lp gas grill
Aussie Vantage 2200 にも：組立・使用マニュアル (16 ページ)

ページを印刷する

1) Disconnect the LP gas cylinder from the gas grill. (See

page 6). Store LP cylinder outside, in a dry, well-ventilated

area, away from sources of heat or ignition.

2) Wrap the Burners with aluminum foil to prevent insects

from entering the burner holes.

3) Wipe the cooking surfaces with a light coat of cooking oil

and wrap in aluminum foil and place inside the Hood or

store inside your dwelling.

4) Place a grill cover over the grill and store it outdoors if

possible. It may be stored indoors only if the LP cylinder is

disconnected from the gas grill.

5) Before next use, remove aluminum foil and wash the

Cooking surfaces.

6) Before using the grill after periods of storage or non-use

(i.e. over winter), check your LP gas grill for gas leaks,

deterioration, proper assembly, and burner obstructions.

7) Periodically check and tighten all nuts, bolts, and screws.

To reduce risk of any bodily injury:

· Always Lock the Grill Hood with the Strap Lock before

transporting and storing this Grill.

· Always transport the grill on the wheels and pull with

the slide bar. Do not attempt to carry the the grill by

grasping the Hood handle. The strap lock will not

support the weight.

· Be careful when towing your grill so it does not roll up

against you.

Your Gas Grill comes with convenient wheels and a slide out

handle for roll-away transport. After the Grill has completely

cooled, cylinder is disconnected and the Grill has been

cleaned:

1) Fold and strap the Grill side tables over the closed Hood.

2) Slide the Left Handle Bar back under the grill.

3) Remove the leg shelf. Release the locking springs and

lower the left end of the Leg Shelf. Lift the other end off

the mounting Hooks on the right legs.

Problem

Burner will not light

using the ignitor

TROUBLESHOOTING

Possible Cause

Not pausing long enough

before clicking the Ignitor

No spark

LP gas cylinder is empty

4) Swing the Gas Regulator up into its storage position

behind the front panel of the Grill and clip it into place.

(FIG. 24A)

5) Fold Legs to locked position under Grill.

6) Store Leg Shelf back in the bottom of the grill and snap

into place.

7) Store Leg Shelf back in the bottom of the grill and snap

into place.

8) Grasp the Right side Handle Bar; lift Grill on wheels and

roll the grill away to storage area. (FIG. 24B) DO NOT

ATTEMPT TO CARRY THE GRILL BY GRASPING THE

HOOD HANDLE.

Store Gas Regulator & Hose

Storage Clip

Fig. 24A

Use Slide Handle

Bar for Towing

Tow-away on Wheels

For Convenient Storage

Fig. 24B

Solution

When lighting the Burner, push in and turn the Control Knob

counterclockwise to "I" when you feel resistance. Pause 4

seconds, then push in and turn the Control Knob until a click is

heard.

The spacing between electrode and Burner ports should be

approximately 3/16". Make sure wire connections are secure

and burner is attached securely to brackets.

Dispose of empty cylinder and replace with a full one.