- ページ 5
スプレッダー Agri-Fab 45-02153-131のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Agri-Fab 45-02153-131 8 ページ。 Agri-fab t100 lb. tow broadcast spreader owner's manual
ページを印刷するREFER
TO
CHARTS
OVERLAP
FIGure 8
ImPorTanT: Application rates shown in the chart are affected
by humidity and by the moisture content of the material
(granular and pellet). Some minor setting adjustments may
be necessary to compensate for this condition.
aPPlICaTIon CHarT (sHIelD uP)
TYPe
maTerIal
Flow seTTInG
FerTIlIZer
Powder
Granular
Pelleted
Organic
Grass seeD
Fine
Coarse
ICe melTer
oPeraTInG sPeeD - 3 MPH. (100 ft. in 23 seconds)
maInTenanCe
CHeCK For loose FasTeners
1. Before each use make a thorough visual check of the
spreader for any bolts and nuts which may have loosened.
Retighten any loose bolts and nuts.
CHeCK For worn oF DamaGeD ParTs
2. Check for worn or damaged parts before each use. Repair
or replace parts if necessary.
CHeCK TIre InFlaTIon
3. Check if tires are adequately inflated before each use. Do
not inflate beyond maximum recommended pressure.
CauTIon: Do noT inflate tires beyond the
maximum recommended pressure printed
on side of tire.
sPreaD
wIDTH
3 - 5
3' - 4'
3 - 5
8' - 10'
3 - 5
10' - 12'
6 - 8
6' - 8'
3 - 4
6' - 7'
4 - 5
8' - 9'
6 - 8
10' - 12'
CleanInG
4. Rinse inside of hopper and exterior of spreader and dry
off before storing.
luBrICaTe (See figure 9.)
5. Lightly apply automotive grease as needed to the sprocket
and gear.
6. Oil the nylon bushings on the vertical sprocket shaft and on
the axle at least once a year, or more often as needed.
7. Oil right hand (idler) wheel bearing at least once a year or
more often as needed.
OIL
FIGure 9
sToraGe
1. Rinse inside of hopper and exterior of spreader and dry
off before storing.
2. Store in a clean, dry area.
serVICe anD aDJusTmenTs
1. If the axle, slotted gear and sprocket assembly is
disassembled, mark down the positions of the parts as
they are removed. The drive wheel and sprocket positions
in relation to the slotted gear determine which direction
the spreader plate will spin. Be sure to reassemble them
in their original positions. (Refer to figure 5 on page 3.)
Use shim washers (Ref. no. 21 on pages 6 and 7) as
needed for minimum backlash. Add grease to gear and
sprocket.
2. If the agitator hairpin becomes damaged or worn it can
be replaced. See figure 10.
AGITATOR
HAIRPIN
FIGure 10
5
OIL
GREASE
SPROCKET
SHAFT