- ページ 7
水ポンプ Aussie Pumps Predator AのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aussie Pumps Predator A 16 ページ。
Mar 2021
B.
Hose Connections
1.
Connect high pressure hose to detergent
injector outlet.
2.
If optional low pressure downstream, in-line
chemical injector is to be used, connect the
injector tube to the detergent inlet and place
the other end of the tube, with the strainer
attached, in the chemical container (not
supplied).
3.
Connect gun/lance assembly to high pressure
hose.
4.
Check inlet water filter is clean then connect
water supply hose to machine. Use a 25mm
(minimum) hose .
Incoming water supply must deliver double the
flow of the machine. If questionable, check
supply at machine. If supply is insufficient, do
not operate from this outlet. For residential use,
the outlet closest to the meter will usually
deliver the highest flow rate. Connect only to
clean town water supply.
Warning: Do not operate from tank or pond.
Doing so will cavitate the pump causing
damage. Cavitation or pump starvation is not
covered
by
warranty.
phenomenon causing vacuum pockets to form
within the pump that eventually implode under
pressure pitting the internal pump surfaces.
Fitting instructions for optional hose reel
1.
Securely clamp the hose reel mounting bar (sold
separately) across the top of the Scud frame
using the two sets of nuts and bolts supplied.
Aussie Pumps recommends using Loctite on the
bolts to prevent them vibrating loose.
WORK SMART ... STAY SAFE
2.
3.
Cavitation
is
a
4.
5.
6.
C.
OPERATE IN WELL VENTILATED AREAS ONLY.
1.
2.
3.
| Aussie Scud, Ultra A & Predator A... Operator's Instruction Manual
Fit hose reel to the mounting bar using the four
sets of nuts and bolts supplied. Ensure all bolts
are securely tightened and use Loctite to
prevent them vibrating loose. The reel should
be positioned so that it rotates fore/aft to aid
fitting whip hose.
Connect whip hose to high pressure outlet on
pump.
Fit handle to reel.
Fit gun to hose using C1500.24 nipple.
Start up machine (see below) and check for
leaks. All leaks must be rectified before using
machine.
Before starting the machine
Ensure machine is level
Turn on water supply.
Pull gun trigger until water starts to flow in a
steady steam then release trigger.
Aussie Pumps
7