- ページ 7

高圧洗浄機 Aussie Pumps AB Scud 30のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aussie Pumps AB Scud 30 16 ページ。 Stainless steel frames, 3,000/4,000 psi
Aussie Pumps AB Scud 30 にも：取扱説明書 (16 ページ)

ページを印刷する

March 2018

NOTE: Check the system for water leaks, fuel leaks,

oil leaks, hose kinks, etc. Correct any problems before

proceeding.

Machine is now ready for operation.

Applying detergent

NOTE: The detergent injection uses a venturi action

and operates when low pressure is selected on the

gun assembly.

For longer hose lengths (over 8m for the AB30 & 10m

for the AB40) the detergent injector will not operate

successfully. Use a foamer lance instead (included

with AB30 hose reel version, otherwise optional).

1. Prepare pressure washer detergent solution as

required by manufacturer.

2. Place detergent siphon tube/filter into solution.

3. Adjust lance to low pressure setting (refer to

section E).

4. Apply cleaning solution to a dry surface, starting at

lower portion of areas to be washed and work

upward, using long overlapping strokes.

5. Allow time for detergent to activate and then rinse

off. DO NOT allow detergent to dry on.

IMPORTANT; You must flush the injection system

after each use by placing siphon hose into a bucket of

clean water, then run pressure washer in low

pressure for 2 minutes.

Using Foamer (supplied with AB30 hose reel version)

1. Using brass nipple supplied

(C1500.06, M22 x ¼M), attach

foaming nozzle to the gun in place of

Vario lance.

2. Prepare pressure washer detergent

solution as required by

manufacturer.

3. Fill foamer bottle and screw into foamer nozzle.

Ensure siphon tube is attached inside bottle.

Aussie AB Scud Cadet Series ... Operation & Maintenance Manual

WARNING .... DO NOT RUN EXCESSIVE BY-PASS

SWITCH MACHINE OFF WITHIN TWO MINUTES OF CEASING OPERATION.

XCESSIVE BY-PASS CAN CAUSE HEAT BUILD UP IN PUMP AND SUBSEQUENT DAMAGE.

EXCESSIVE BY PASS RUNNING VOIDS WARRANTY!!

4. Spray angle can be adjusted by rotating the nozzle

cover. The amount of foam delivered is adjusted

with the knob on top.

5. Apply cleaning solution to a dry surface, starting at

lower portion of areas to be washed and work

upward, using long overlapping strokes.

6. Allow time for foam to activate and then rinse off.

DO NOT allow foam to dry on.

IMPORTANT: rinse foamer nozzle & bottle with clean

water after every use to prevent clogging.

Stopping the machine

1. If using the detergent injector, flush out the

chemical by running clean water through the

system.

2. Allow machine to run for 1 minute without load

to cool before stopping.

3. Turn engine ON/OFF switch to OFF

4. Pull recoil start until compression resistance is

felt. Store the machine in this position to help

prevent valve warpage or sticking.

5. Close fuel valve.

FAILURE TO CLOSE THE FUEL VALVE ON THE

ENGINE CAN CAUSE FUEL LEAKAGE WHEN THE

MACHINE IS BEING TRANSPORTED!

6. Turn off water supply.

7. Pull gun trigger to release all pressure in the

system, then LOCK THE TRIGGER.

8. Hoses may now be disconnected from the

machine.

Failure to release pressure before disconnecting the

hose quick coupler will result in the quick coupler o-

ring seal blowing out. This o-ring must be replaced

before operating machine.

Aussie Pumps