- ページ 7

超音波ジュエリークリーナー Aussie Pumps Eco Clean Super IndyのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aussie Pumps Eco Clean Super Indy 20 ページ。 High pressure washer

ページを印刷する

The most important instructions

are marked with the symbol:

INTRODUCTION

This manual must be read before installing, setting up and

using the cleaner. The manual is an integral part of the product.

It is composed of two parts, one of which is yellow.

Read the warnings and instructions in this manual carefully as

they provide important indications as to SAFETY IN USE and

MAINTENANCE, paying special attention to the general rules

for safety listed in the yellow booklet.

KEEP THIS MANUAL CAREFULLY FOR FUTURE CON-

SULTATION.

The contents of this booklet must be brought to the attention

of persons using or carrying out routine maintenance on this

water cleaner.

CLASSIFICATION

The user must observe the conditions of use of the applian-

ce prescribed by the Rules, and particularly he must respect

the following classification:

As for the protection against electric shock, the H.P.cleaner

belongs to CLASS I.

The H.P. cleaner is factory set and all its safety devices are

sealed. It is forbidden to alter their adjustment values.

The water in this machine is heated by a diesel fueled burner.

The H.P. cleaner must be always used on a firm and flat

ground, furthermore it must not be moved while it is working or

connected to the electric supply.

Failure to observe this prescription may cause danger for the

user.

The H.P. cleaner must not be used in the presence of corrosive

or potentially explosive atmospheres. (vapours or gas).

The electrical installation must be performed by qualified tech-

nicians who are able to work in observance of the governing

rules (in compliance with the provisions of the IEC 60364-1

standard) and of the manufacturer's instructions.

Any damage to persons or property as a result of incorrect

electrical installation is not the responsiblity of the manufac-

turer.

Machines under 3kW are fitted with a plug. Check the data plate

on the machine and ensure that the power source is suitably

Aussie Eco-Clean Super Indy Operating & Maintenance Manual - 2020

rated and earthed. If an alternative plug needs to be fitted use

a qualified electrician.

Do not use extensions to feed the H.P. cleaner.

The electric safety of this machine may be assured only when it

is properly connected to an efficient grounding system in accor-

dance with the governing laws for electric safety. (in compliance

with the provisions of the IEC 60364-1 standard).

It is necessary to check this essential safety requisite. In case

of doubt, ask for accurate control of the power system by

qualified personnel.

The manufacturer may not be considered responsible for dama-

ges occurred because of the lack of the grounding system.

The H.P. cleaner must be connected to the electric supply by

means of an omnipolar switch with opening contacts of at least

3 mm. This switch must have electric features which are consi-

stent with the appliance. (This requisite does not apply to H.P.

cleaners with plug and electric power lower than 3 kW).

The appliance is disconnected from the electric supply only by

pulling out the plug or switching off the omnipolar switch.

Failure to respect the above absolves the manufacturer of all

liability and represents negligent use of the product.

The water cleaner is considered as a fixed device.

Water cleaners with the "Total Stop" device should be con-

sidered as off when the omnipolar switch is in the "O" position

or the plug is unplugged from the socket.