- ページ 2

自動車アクセサリー AUSSIE TONNEAU ATB01018のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。AUSSIE TONNEAU ATB01018 4 ページ。 Cover for ford px ranger dual cab (with head board), nov 2011-may 2013

ページを印刷する

NOTE

Read entire instructions prior to start.

STEP 1

Fit the pieces of angle to the outside edge of the head board making sure the top flat edge of the

angle is at the same height as the top lip of the head board. Drill two 4mm holes in each piece of

angle, silicone behind is, then rivet into place

STEP 2

Using two pieces of dowel, join the 3 aluminum rope tracks together. Place the other 2 pieces of

dowel in the ends of the now joined rope track.

STEP 3

Rest the aluminum rope track on the pieces of angle already fixed in place, and push forward to

the vertical face of the head board.

STEP 4

Using a 4 mm drill bit, drill 6 holes 50mm from the end of each of the aluminum rope

tracks into the front of tub.

STEP 5

Once all the holes have been drilled, remove the dowelling pieces. Squeeze silicon

sealant along the back of the rope tracks and pop rivet into place.

STEP 6

Slide the front of the tonneau cover through the aluminium rope track section

STEP 7

To fit the bar brackets, measure 743mm back from the inside front edge at the top of the

tub and place them as shown in Figure 2. (5mm down from top edge of tub) Drill and

rivet using two large rivets for each Bar Bracket. Install the support bar according to the

supplied instructions.

STEP 8

To fit round body hooks to the tail gate, measure 465mm up from the bottom edge of the

tail gate and line up each hook individually to each bunji loop starting with the two either

side of the tailgate handle and working your way to the outside, drill and rivet buttons

alternating from side to side.

To fit round body hooks to the sides of the tub measure 155mm down from the inside

STEP 9

edge and line up each hook individually to each bunji loop. Start with the two rear bunjis

and work your way around to the front, drill and rivet buttons alternating from side to

side.

STEP 10

To fit Tonneau lock Bracket refer overleaf

STEP 11

Your Tonneau Cover is now fitted.

INSTALLATION PROCEDURE