- ページ 7

モニター Datavideo TLM-434HのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Datavideo TLM-434H 12 ページ。 4x 4.3” sd / hd monitor

Rear Panel

SDI / HD-SDI input and Bypass

BNC connector for SDI / HD-SDI Input and Bypass / Loop through.

Bypass / Loop through BNC connector only works with SDI / HD-SDI input.

HDMI input

HDMI digital signal input connector.

Support HDMI 1.1

15Pin D-Sub Tally Input

Send in red and yellow colour tally signal to tally LED. Red means on-air, yellow means

standby. See below table.

DC in socket

Connect the supplied 12V 3A PSU to this socket. The connection can be secured by

screwing the outer fastening ring of the DC In plug to the socket.

D-Sub 15pin Female

The pin assignment of the Tally Connector is shown in the following table:

Panel / Source

A / 1

B / 2

C / 3

D / 4

Connect the TLM-434H power supply to the DC In socket. Ensure the power cable is connected to a suitable

mains socket.

Switch the power On/Off switch to the ON position and all 4 panels will become active.

On Air - Red LED

Pins 1 & 4

Pins 6 & 4

Pins 11 & 4

Pins 5 & 4

Standby - Yellow LED

Pins 3 & 14

Pins 8 & 14

Pins 13 & 14

Pins 15 & 14