- ページ 3

ホームオートメーション DVS EC RECLAIM CONNECTのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DVS EC RECLAIM CONNECT 6 ページ。

House

In the "roof space" section of the house you can see the blue air supply humidity level bar indicator. Also, an elongated

hexagonal shape which represents the heat exchanger. The "inside" section of the house shows you the temperature

of the air supply (Supply Fan) measured after the heat exchanger and the temperature measured at the Connect

control panel (House). You will also see a second blue bar humidity level indicator showing the humidity measured at

the Connect control panel. Finally, a black bar CO

humidity levels indicated are Absolute Humidity.

DVS®

Touch the DVS® logo briefly and our phone number will appear.

Airflow Control

Touch this to quickly adjust the airflow up or down.

The bottom bar

The bottom bar is where you will see any system notifications appear.

levels

Note: The system is equipped with one CO

the CO

control function is enabled (using the Settings menu) the system is programmed to increase the ventilation

rate when the CO

level rises above 1000ppm. For specific CO

diagnostics menu. The system can be fitted with up to 4 of these remote sensors. When more than one sensor is

fitted the system calculates the average CO

How to adjust or check on the operation of

your DVS®

Note: The system is programmed at the time of installation

according to the size of your home.

Most Customers find they don't need to make any

adjustments to their system. The system costs very little

to run and is programmed to give optimal ventilation

performance for your home whilst being as unobtrusive as

possible. However, if you need to make adjustments or to

check on what the system is doing, the instructions below

are a handy guide for you.

Turning the system ON or OFF

Touch the settings icon

at the top right of the home

screen then –

. The system is now OFF. To turn

POWER OFF

the system ON – touch the screen. The system will re-start.

Help icon

Where applicable, the settings adjustment screens will

also contain a

. If you touch that you will be given an

explanation of the nature of the settings and if applicable

the effect of adjusting them.

For further assistance please call DVS

level indicator measured at the remote CO

sensor. A plug-in device which pairs with your Connect control panel. If

level information see the graphs section of the

concentration across the sensors.

Fan settings

Adjusting your fan settings increases or decreases the

level of ventilation or how aggressive your system is. Your

system has been programmed for your home. The DVS® will

typically perform well without the need to make fan settings

adjustments. However, you are of course able to make

adjustments.

Fan Speed programming adjustment

Touch settings icon

FAN CONTROL

down (to the left) –

This setting changes the programmed fan speed for your

system. This setting adjusts how passively or aggressively

the system behaves.

Note: if you adjust the programmed fan setting up or down

and notice any reduction in the performance of the system,

you can revert back to the typical programming for your

home by adjusting the setting back to the half way point.

on 0800 387 387

sensor(s) in the home. The

then –

SETTINGS > FAN SETTINGS >

– Slide the Fan Speed bar up (to the right) or

OK > EXIT > EXIT