ページを印刷する
EN
Dateq Crew Manual
Zone volume control
By means of this input the volume of an external zone can be adjusted. The volume control can be
connected in two different ways:
Supplying an external voltage
When a voltage is supplied between the tip and the shielding of one of the cinch-connectors the
volume will be attenuated (for both the left and the right channel). When a negative voltage is
supplied the signal will be amplified. The amplification ranges from +14...-80dB. The graph below
shows the amplification as function of the applied voltage:
20
10
0
-2
0
-10
-20
-30
-40
-50
-60
-70
-80
Voltage at 'volume control' (V)
Connecting a potentiometer
It is also possible to connect a potentiometer between the tip and the shielding to one of the cinch
connectors. The attenuation ranges from 0...-80dB. A 10kOhm logarithmically potentiometer gives
the best results. The next graph shows the attenuation as function of the angle of rotation:
90
80
70
60
50
40
30
20
10
0
0
10
20
additional output zones can be connected.
When an adjustable attenuation is not necessary a cinch connector with a short-circuit between the
tip and shield must be connected. When the input is left open the volume will be fully attenuated.
2
4
6
30
40
50
60
Rotation angle potentiometer (%)
Connections
8
10
70
80
90
100
7
As a maximum four