- ページ 6

アウトドアカート Agri-Fab 45-0350のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Agri-Fab 45-0350 12 ページ。 Atv tandem axle cart farm tandem axle cart
Agri-Fab 45-0350 にも：補修部品 (2 ページ), オーナーズマニュアル (12 ページ)

ページを印刷する

17. Place the latch lock lever through the slot in the tongue.

Insert the 5/16" x 4" hex bolt through one side of the

tongue. Assemble a (SEMS) hex nut, the lever and another

(SEMS) hex nut onto the hex bolt. Insert the hex bolt

through the opposite side of the tongue and assemble

a 5/16" nylock nut onto the end of the hex bolt. Tighten

so that the hex bolt can still rotate freely. Tighten the two

(SEMS) hex nuts against each side of the latch lock lever

so that it is centered in the slot. See figure 8.

LATCH LOCK LEVER

5/16" x 4"

HEX BOLT

FIGure 8

18. Hook the short end of the spring into the hole in the

latch lock lever. Use the spring puller tool to hook the

long end of the spring into the square hole in the tongue.

The spring puller tool can be stored when finished. See

figure 9.

SPRING PULLER TOOL

FIGure 9

5/16" SEMS NUTS

LATCH

LOCK

LEVER

5/16"

NYLOCK

NUT

LONG END

OF SPRING

LATCH LOCK LEVER

19. Assemble the end of the hitch bracket (two holes) up

through the slot at the front of the drawbar tongue.

Fasten it to the tongue using the 3/8" x 1" hex bolt and

3/8" nylock nut. Tighten. See figure 10.

20. Assemble the hitch pin through the hitch bracket and

the tongue and secure it with the 1/8" hair cotter pin.

See figure 10.

3/8" x 1"

HEX BOLT

HITCH

BRACKET

FIGure 10

21. Assemble a 1" thin washer, a walking beam and another

1" thin washer onto the pivot axle. Insert a cotter pin into

the axle and spread the ends. Press a hub cap onto the

flat washer. Repeat on the other end of the pivot axle.

See figure 11.

noTe: Eight extra 1" flat washers are provided to take up

end play if necessary.

1" THIN WASHER

1/8" x 1-1/2"

COTTER PIN

HUB CAP

FIGure 11

1/8" HAIR

COTTER

3/8" NYLOCK

NUT

HITCH PIN

WALKING BEAM