- ページ 10

エンジン AUSTRALIAN MADE GREAT MATEのPDF インストールとセットアップの説明をオンラインで閲覧またはダウンロードできます。AUSTRALIAN MADE GREAT MATE 20 ページ。 Double swing gate motor kit

Place a spirit level (or a straight piece of wood with a small spirit level), on the top of the gate frame

approximately 800mm to 900mm from the inside of the hinge post. Level off the spirit level and mark the

post on the underside of the spirit level.

Measure upwards 20mm from this mark and draw a straight line. Place the bottom edge of the mounting

cradle on this line and mark and drill the mounting holes or use the mounting template included in these

instructions.

Check the 4 spacer tabs are in place on the back of the mounting cradle. If a spacer tab has fallen off

then attach it with silicon otherwise use packing washers to replace the spacer tab. The spacer tabs allow

the lip of the motor cover to be correctly fitted over the mounting cradle and drive assembly.

Firmly attach the mounting cradle to the post and check that the cradle is level. Fit the drive assembly into

the cradle. Ensure the washers are in place and fully tighten the 4 nuts to firmly secure the drive assembly

in the mounting cradle.

Gate

Frame

4 Spacer Tabs

Place the bottom edge of the mounting

cradle on this line and mark and drill the

mounting holes. Firmly fit mounting cradle

and ensure it is level.

GATE MOTOR

INSTALLATION AND SET UP

INSTRUCTIONS

Mounting the Gate Motor (con't)

Spirit Level

Lip of the motor

cover correctly

fitted over the

mounting cradle

Spirit Level

Mark post on the underside of level then

measure up 20mm and draw a straight line

Fit the drive assembly into the cradle. Ensure the

washers are in place and fully tighten the 4 nuts to

firmly secure the drive assembly in the mounting

cradle.