- ページ 17

ドア開閉システム Cookson FDO-A10EのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Cookson FDO-A10E 19 ページ。 Industrial duty fire door operator

CHECK AT THE INTERVALS LISTED IN THE FOLLOWING CHART.

ITEM

Drive Chain

Sprockets

Fasteners

Bearings/Shafts

Gearbox - The gearbox on the motor operator is factory sealed, and non vented, and should not

require service for the life of the operator.

Brake Friction Material - The electromagnetic brake on the motor operator is factory adjusted,

and should not require service for the life of the operator. Should service be

required, the entire unit should be replaced.

* - Use SAE 30 Oil (Never use grease or silicone spray)

Do not lubricate motor. Motor bearings are lubricated and sealed at the factory.

Inspect and service whenever a malfunction is observed or suspected.

CAUTION: BEFORE SERVICING, ALWAYS DISCONNECT OPERATOR FROM POWER SUPPLY.

WHEN ORDERING REPAIR PARTS PLEASE SUPPLY THE FOLLOWING INFORMATION:

PART NUMBER - DESCRIPTION - MODEL NUMBER - JOB NUMBER

Operators require practically no special maintenance other than periodic checking to see that

mechanical parts where necessary are lubricated and the electrical components are free of dirt.

The Service Technician should familiarize himself/herself with the proper sequence of operation

and all related controls. Power to operator must be disconnected when removing or replacing

covers on electrical components, making adjustments, or performing maintenance.

9001(7) ECN 1057 4/10/010

MAINTENANCE SCHEDULE

PROCEDURE

Check for excessive slack.

Check & adjust as required.

Lubricate.*

Check set screw tightness

Check & tighten as required

Check for wear & lubricate

ADDRESS ORDER TO:

COOKSON ROLLING DOORS

2417 S. 50TH AVE

PHOENIX, AZ. 85043

(602) 272-4244

ATTN: CUSTOMER SERVICE

MOTOR OPERATOR MAINTENANCE

EVERY

3 MONTHS

6 MONTHS 12 MONTHS

EVERY