- ページ 7

ミキサー AUSTRALIAN MONITOR MX883のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。AUSTRALIAN MONITOR MX883 12 ページ。 8 channel stereo mic/line mixer

ページを印刷する

1. R Ear Pa Nel

INPUT CONNECTIONS

For wiring balanced in, pin 2 is hot. Unbalanced wiring on the microphone

inputs is not recommended. Balanced input wiring (shielded pair cable) is

recommended.

Unbalanced RCA wiring should be keep as short as possible. Typically less

than 3m.

LINE OUTPUT

The LINE output XLR can be used to connect up to 6 booster ampliﬁ ers.

Balanced wiring (shielded pair cable) is recommended.

NOTE: When wiring the LINE output as unbalanced, Pin2 should

be wired as hot and Pin1 should be wired as ground/shield.

Do not wire Pin3.

RECORD OUTPUT

The Record output wiring should be kept as short as possible. Typically less

than 3m.

DIRECT OUTPUT

The direct outputs are balance and should be wired tip hot. When wiring the

direct outputs as unbalanced or when using a mono jack the ring and sleeve

should be connected together and to the shield.

T R O UBLE SH OOTI NG GU ID E

TROUBLE

Power LED not on

Noisy output

Distorted sound

No sound but unit is on

Tones and/or VCA control does not work

Condenser microphone does not work

M X 8 8 3 I N S TA L L AT I O N & O P E R AT I O N M A N U A L

I N S TA L L AT I O N A N D T R O U B L E S H O O T I N G

LIKELY CAUSE

Power not reaching unit

Incorrect gain structure

Input is overloaded

Output is being over driven

Bass control is turned up

Volume turned down

Module not installed

Phantom power not switched on

REMEDY

Check mains connection

Check mains fuse

Check power switch is on

See setup guide

Check MIC/LINE switch

Reduce input level at source

Reduce output volume

Reduce Bass control level

Check volume controls

Purchase optional modules

Switch on phantom power

PA G E 7