- ページ 4

ゲートオープナー Cookson FKAのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Cookson FKA 17 ページ。 M100 firegard chain; m100 firegard crank

IMPORTANT MECHANICAL INSTALLATION PROCEDURE
WARNING
To reduce the risk of severe injury or death:
-
1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2. Spring tension must be adjusted to allow the fire door to self close during a drop test, alarm
activation and/or power failure. A door that is operating improperly could cause severe injury. Have
qualified door system technicians make repairs to spring assemblies and other hardware before
installing the operator.
3. Cover any exposed, moving operator parts that are less than 8 feet above the floor.
4. Do not connect the door operator to the source of power until instructed to do so.
5. When utilized, locate the "close" control station: (a) within sight of the door, (b) at a minimum
height of 5 feet so small children cannot reach it, and (c) away from all moving parts of the door.
6. Instruct the end user on operation of the operator / release device.
7. The door is under extreme spring tension. Have qualified door system technicians make all
necessary adjustments and repairs to the door.
8. Make sure the available alarm power supply to be connected to the operator is of the same voltage,
frequency, phase and wattage as indicated on the nameplate of the alarm box.
9. Read and understand the wiring diagram of the alarm box (if applicable), and any other equipment to
be connected to the operator.
10. Always disconnect power whenever installing or servicing the door or operator.
3
TM
M100 FireGard
Chain & Crank
02/11