- ページ 12
プール掃除機 AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-20のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AUSTRALIAN POOL EQUIPMENT PRISTINE PRI-20 12 ページ。 Auto self cleaning
ページを印刷するPUMP PROTECTION
Enter the MAIN MENU by pressing the [MENU] button.
Use the [▲] and [▼] buttons to
navigate the MAIN MENU until
the arrow indicates that you have
reached PUMP PROTECTION.
Press the [ENTER] button to enter
into the settings.
Press the [▲] and [▼] button
to toggle the PUMP PROTECTION
feature ON or OFF.
Press the [ENTER] button to save
the selection made and the arrow
pointer will move to the next line.
Press the [▲] and [▼] buttons to set the PUMP PROTECTION timeout value to your
desired setting. This value can range between 1 and 10 minutes.
Press the [ENTER] button to save your changes and return to the MAIN MENU.
Press the [MENU] button once more to exit the MAIN MENU and return to the MAIN
OPERATING SCREEN.
PUMP PROTECTION when activated provides additional protection to the pump in the
case of a blockage or plumbing fault. PUMP PROTECTION will prevent the pump from
running dry for prolonged periods of time which may cause undue wear or damage to
the pumps seals. One a PUMP FAIL condition has arisen due to a blockage or
plumbing fault, the chlorinator will cease to operate for a period of one hour. If after an
hour, the chlorinator is still scheduled to run, it will start up again in the hope that
remedial action has been taken, or the condition which caused the PUMP FAIL
condition has cleared on its own accord.
Mode Select
Chlorine Output
TimerSettings
Pump Protection
On
Fail After 10 min
Page 11
CELL CLEANING
Enter the MAIN MENU by pressing the [MENU] button.
Use the [▲] and [▼] buttons to
navigate the menu until the arrow
indicates that you have reached
SET TIME. Press
the [ENTER] button to enter
into the settings.
Use the [▲] and [▼] buttons to set
the number of hours (between four
and twelve hours) you wish to
clean the
cell.
HOW DOES THE NUMBER
OF HOURS I SELECT CLEAN MY CELL?
The Pristine Cell is constructed of special material that is coated on both sides; this
enables the cell to work in forward or reverse. Should you leave the recommended
default of 12 hours, the cell will go forward for 12 hours of operation and then in reverse
for the next 12 hours of operation.
Every time the cell changes the direction of operation, this assists in
cleaning the calcium from the plates.
HOW MANY HOURS SHOULD I SELECT?
For most swimming pools 12 hours will be efficient for keeping the cell clean. The
cleaning process generally happens over an hour after the cell changes direction. If
you watch the cell during the beginning of a new cycle and it doesn't appear to be
cleaning all of the calcium off, you may need to reduce the number of hours that the
cell cleans.
IMPORTANT: If you must reduce the time between cycles, test and measure by
one hour at a time. The greater the time difference between cell cycles, the
longer your cell will last.
CLEANING TIP
Every few months a self cleaning cell still requires cleaning in acid, however you may
like to reduce the time between cycles every few months to 4 hours for one to two days
to help lift built up calcium and then increase the time difference to your standard
setting once clean.
This method could help reduce manual cleaning to a few times per year.
Chlorine Output
TimerSettings
Pump Protection
Cell Cleaning
Clean Cell Every:
12 Hours
Page 12