- ページ 3

掃除機 Australian Pump Industries Clean Air 753のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Australian Pump Industries Clean Air 753 4 ページ。 Industrial wet/dry

ページを印刷する

1.5

In The Case Of An Emergency

▪

Pull out the mains connector plug.

▪

Immediately apply recognised first aid measures.

▪

Do not resume operation until machine has been checked by a qualified technician.

1.6

Electrical connection and supply

▪

240 volts.

1.7

Warning

▪

Do not collect dust that may contain asbestos material with this machine.

▪

The cleaner should never be used for picking up hot ashes, explosive fluids or undiluted acids

or solvents. These include petrol, paint thinner and heating oil, all of which can generate

explosive mixtures or vapours when mixed with the suction air. Acetone, undiluted acid and

solvent may damage the materials of the machine.

▪

For cleaning or servicing the machine or when replacing parts the motor should be switched

off and the electric plug be withdrawn from the socket.

▪

Care should be taken to ensure that the electric cable is not damaged by being driven over,

crushed or strained. Care should also be taken to ensure the electric cable is not pulled

through pools, water or spills.

▪

Check electric cable regularly for any signs of damage, ageing or fraying.

▪

The machine must not be used if the electric cable is not in a proper condition.

▪

It is advised when using equipment that earmuffs be used during operation of the unit.

▪

Do not hose down the vac head as water may enter the unit and damage the motors.

▪

When using your machine for wet use only ensure that the fabric filter is NOT installed in the

recovery tank.

▪

Never allow the liquid to exceed maximum level in recovery tank; i.e. when the float inside the

machine rises to the vacuum cleaner head causing suction to be cut off, immediately empty

the recovery tank.

▪

For dry use the fabric filter bag must be fitted to protect motor.

OPERATION

2.1

Assembling Your Machine

▪

Open the clasp and lift off the suction head.

▪

Take the accessories out of the tank if they are packed this way.

▪

Replace the suction head on the tank and close the clasp.

2.2

Preparation For Use

▪

Fit the hose into the suction hose connection until it clicks.

▪

Assemble the suction tubes and fit to the hose.

▪

Fit correct accessory to suction tube.

2.3

Filter Usage

▪

Fit fabric filter in tank for suction of dry dust.

▪

Remove fabric filter from tank for suction of liquids if your machine is a wet/dry model.

2.4

After Use

▪

Empty tank after use.

▪

Shake filter bag to dislodge dust before removing from tank.

NB. Vacuum cleaners with 2 or 3 motors can be used with 1 or more motors.

NORMAL CARE & MAINTENANCE

ATTENTION: Remove plug from socket before any maintenance operation on

▪

Clean the machine inside and outside.

▪

Check the filter bag for holes or signs of wear and tear to avoid microscopic particles entering

your motor.

▪

Empty and clean filter bag after every use. NB. If you clean the filter with water, ensure that it

is dry before you replace it.

▪

Clean the rubber which is in the cover of the head.

▪

Check the hoses and the electric cable.

▪

We recommend that the carbon brushes on your motor are replaced every 200 hours.

May 2015

WARNING – This appliance must be earthed!

the head of the machine.

Aussie Eco-Clean Industrial Wet/Dry Vacuum Cleaners