- ページ 4

ケトル Cookworks KE01301YA-CEのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Cookworks KE01301YA-CE 8 ページ。 Illumination kettle

To use

1. Place the kettle and stand on a stable, flat, heat resistant surface

and away from surfaces that may be damaged by steam.

2. Fully unwind the cable from the stand and plug in. For safety do

not allow the cable to dangle over the edge of units.

3. Remove the kettle from the stand; press the lid button to open

the lid. Fill to the required level using the markings on the clear

water gauge as a guide. Do not fill past the MAX (1.7 litre) or

below the MIN (0.5 litre) level.

4. Close the lid fully until it clips into place and ensure that the

switch is in the off position (lift switch up) before replacing on the

stand.

5. Turn the kettle so that the spout faces away from you and switch

the kettle on by pressing the switch downward (I). The kettle will

start to operate and lights within the kettle will illuminate.

6. When the water boils, the kettle will switch off automatically and

the lights will go off.

7. To stop or interrupt the boiling process, switch the appliance off

by lifting the switch up before removing the kettle from the stand.

Notes:



Before using for the first time, fill the kettle to the maximum level,

bring to the boil and then discard water. Repeat this step two

further times.



This kettle is fitted with a safety device that automatically

switches off the heater element if the appliance is inadvertently

switched on when empty or if it boils dry. In this case allow the

kettle to cool completely (minimum 15 minutes) before refilling

with cold water. The kettle will resume operation after refilling.

Issue 1 29/6/2017