- ページ 3

電気ヒーター Austria Email EBH-KDWのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Austria Email EBH-KDW 14 ページ。
Austria Email EBH-KDW にも：取扱説明書 (14 ページ)

SAFETY INSTRUCTIONS

General

• This immersion heater can be used by children eight years old and older as well as by persons

with reduced physical, sensory or mental capabilities or who lack experience and knowledge

if they are supervised or if they have been trained with regard to the safe use of the immersion

heater and understand the resulting risks. Children may not play with the immersion heater or its

packaging. Cleaning and user maintenance may not be performed by children without supervi-

sion.

• The immersion heater may only be installed and operated as described in this manual or the

associated technical information. Any other use is not proper and is therefore impermissible.

• A defective immersion heater may not continue to be operated.

• There is a risk of scalding from hot water or hot components (e.g. fittings, hot water outlet pipe,

etc.).

• The immersion heater is not suitable for operation in aggressive media (alcohol, glycol, oil, ba-

ses, acids, etc.).

• When using an electric immersion heater, proper corrosion protection is to be ensured.

• Only use original accessories or original spare parts from the manufacturer.

Installation and commissioning

• Installation and commissioning may only be performed by qualified specialised personnel who

therefore assume the responsibility for the proper assembly according to the applicable laws,

standards and guidelines.

• The immersion heater may only be installed in dry, freeze-protected spaces.

• The data specified on the nameplate (immersion heater as well as tank) must be observed.

• Prior to the commissioning of the immersion heater, the heating rods must be completely sur-

rounded by water.

Electrical Connection

• Only qualified specialised personnel may connect the immersion heater to fixed lines while ob-

serving the relevant professional standards and laws.

• A ground fault circuit interrupter with a trip current of I∆n ≤ 30mA must be installed upstream

from the electrical circuit.

• The electrical connection is to be carried out exclusively according to the connection diagram

adhered to the inside of the protective cap!

• Before working on the immersion heater, this is to be de-energised, checked for the absence of

voltage and secured against being switched on again.

• If a connection cable is damaged, immediately unplug the power plug and call a professional!

• Connection cables may not be extended or cut through in any way.

• ATTENTION: The factory wiring must not be altered!

Servicing

• Maintenance, cleaning and any necessary repair or service work may only be performed by spe-

cialised personnel who are qualified for this purpose.

• Never try to fix errors and faults yourself.

• Necessary service and maintenance intervals are to be observed in accordance with these ope-

rating and assembly instructions.

Id.Nr.: 228557-15