ページを印刷する
Assembly to ADE column scale:
Place the assembling block for fixing the height rod at the backside of the column over the two holes
at the column of the scale. Use the 2 x M5 screws and turn them carefully tight. Place the height rod
with the printed side onto the assembling block by using the two mounting holes and fix the rod by
using the M6 screw (lower hole). Make sure that the screw is tightened well.
Assembling to the wall:
Carefully measure with an exact measure 56 cm from the floor and mark the wall.
Pull out the height rod to full length. Exactly place the height measure over the
marking at the hole beneath the 60 cm point on the height measure. Use a spirit
level to align the height rod and mark the wall at the second fix point at 122,5 cm.
Drill holes right at the marking and use the supplied dowels.
You will need 1 washer for the lower screw. Slide the washer over the screw and
insert the screw through the lower hole of the measuring rod from the printed side.
Do the same with the second screw using the upper hole. Now place the two
spacers over the screws. Place the two screws into the dowels. Make sure both
screws have been carefully tightened.
Safety advice
Follow the instructions of the Operating Manual
Attach the height rod only on ADE column scales
After finishing the measurement make sure to fold
the measuring tongue down to avoid danger of injury.
Operating Instructions
1
Adjust the measuring tongue to a horizontal position
2. Slide the measuring tongue up just above of the person to be measured
3. Slide the measuring tongue down to the person's head
5. Take the result from the readout point
6. To measure below 134 cm, please press the button at centre of the measuring tongue
and slide the measuring tongue down. Please read the length at the red line.
Warranty – Liability
ADE will repair or replace this product within a period of 2 years from date of delivery applying to
defects occurred due to poor material or workmanship (presentation of invoice is necessary). All
moveable parts – batteries, cables, mains units, rechargeable batteries etc. – are excluded. Warranty
does not include natural wear, damages caused by incorrect or negligent handling, overuse or
unsuitable or improper storage. The cost of transport will be borne by the customer should the
equipment be located anywhere other than the customer's premises. In the event of transport
damage, claims under warranty can be accepted subject to using the complete original packaging and
the equipment secured the way it was packed and secured originally. All the packaging should
therefore be retained.
Any warranty claim will be rejected if the equipment is opened by persons not authorized expressively
by ADE to do so.
Customers abroad are kindly requested to contact their local dealer for any warranty claim, customer
service and spare parts.
6
Installation
MZ10023-140325-Rev005-UM-d-e-fr-nl