- ページ 7

ストーブ Austroflamm ChesterのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Austroflamm Chester 16 ページ。

ページを印刷する

english

Floor load capacity

Make sure that the load capacity of the supporting

construction is sufficient to carry the weight of the

, before the heating unit is installed.

entire unit

Combustion air

Being the user of the stove you must take care of a

sufficient combustion air supply. Sealed-up windows

and doors may not allow a sufficient combustion air

supply or disturb the draught behaviour of your stove.

Please ensure the additional supply of fresh

3. CORRECT OPERATION OF YOUR STOVE

Approved fuels

Dry, well cured and natural wood (hardwood

preferred), wood briquettes, lignite briquettes.

Maximum amount of fuel

Maximum amount of fuel to be added: 1,6 kg wood or

briquettes. Larger amounts of fuel can lead to

overheating and thus damage the stove.

Clean burning

The wood must be dry (relative wood moisture

< 15%) and untreated and the right amount of wood

must be burned in order to ensure a clean fire that

releases only small amounts of emissions.

Making a fire

For the correct and safe operation of your stove

please pay attention of the chimney developing the

necessary feed pressure. This must especially be

considered before the initial operation (or e.g. after

the summer heating break) and during the mid-

season heating periods (e.g. at strong wind, etc.).

Turn the air control knob to the left "+" position.

Put 2-3 logs of wood at the firebox bottom (1) and put

the kindling (2) on top. Place a wood lighter aid on top

and in the middle of the kindling, light it (see fig. 3)

and close the door.

Figure 3:ignite the fire

combustion air if necessary. For details please

consult your specialist retailer

Stove pipe connection

For your own safety stringent laws apply for

connecting the stove pipes to the chimney. Your

professional dealer or distributor knows these laws.

Please have your certified retailer carry out the

connection of your stove

As soon as the surrounding logs are burning well

enough you can start controlling the heat output

(control knob on maximum "+" = maximum heat

output). The flames shall always look yellow and

never blue (otherwise please add more air) – see

fig. 4.

The recharging is principally done the same as the

starting up of the stove: turn the air control knob to

the

maximum

CAREFULLY, place wood in the firebox cautiously,

close door. Wait until the newly added wood is

burning properly and subsequently control the heat

output by adjusting the air knob as desired.

Heating in-between seasons

If you heat the stove in between seasons, when the

outside temperatures are higher, the flue gases may

not be able to escape completely and this may lead to

disturbances in the chimney draught, especially if the

temperatures are rising suddenly. The stove has to

be charged with less wood then and the primary air

has to be increased so that the wood can burn down

faster (with visible flames) and thus the chimney

draught can stabilize.

Figure 4:

air control knob

"+"

position,

open

Chester

stove

door