- ページ 6

モニター Bender DPM2x16FPのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Bender DPM2x16FP 16 ページ。 For use in electric vehicle (ev) charging stations, wall boxes and street light charging points

ページを印刷する

1.4 Inspection, transport and storage

Inspect the dispatch and equipment packaging for damage, and compare the

contents of the package with the delivery documents. In the event of damage

in transit, please contact Bender immediately. The devices must only be

stored in areas where they are protected from dust, damp, and spray and drip-

ping water, and in which the specified storage temperatures can be ensured.

1.5 Disposal

Abide by the national regulations and laws governing the disposal of this de-

vice. Ask your supplier if you are not sure how to dispose of the old equip-

ment. For more information on the disposal of Bender devices, refer to our

homepage at

www.bender.de -> Service & support.

1.6 Intended use

This manual provides a description of the Display module, which can only be

used in combination with Bender charge controllers. The charge controller is

designed for use in electric vehicle (EV) charging stations, wall boxes and

street light charging points. This document should be used together with the

Charge Controller operating manual(s), which can be downloaded from:

www.bender.de/en/service-support/downloads.

The Display module is a separate board and displays the current status infor-

mation as well as the charge status. The Display module can be connected to

the charge controller, the main component of a charging point, using a

standard RJ45 cable. The second RJ45 cable can be connected to the RFID

module.

CAUTION

Electrostatic discharge (ESD) may cause damage to electron-

ic components. Observe precautions for handling electro-

static sensitive devices according to DIN EN 61340-5-1 and

DIN EN 61340-5-2.

DPM2x16FP_D00296_01_M_XXEN/09.2017

Important information