- ページ 6

自動車バッテリー充電器 4x4Tough 15-50222のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。4x4Tough 15-50222 8 ページ。 Ump starter with compressor

If the jump starter LED light is green this indicates battery polarity connection is correct. WARNING: If the

jump starter LED light is red and an alarm sounds this indicates reverse battery polarity which is

incorrect. STOP! Carefully disconnect the jump starter clamps. Reconnect the jump starter clamps

correctly. Refer to points 4 & 5 above.

Turn the jump starter ON/OFF Switch to the ON position.

Try to start your vehicle. If your vehicle does not start after the first attempt, wait 3 minutes before trying

again. (Failure to wait may damage the jump starter).

CAUTION: Excessive engine cranking can damage the vehicles starter motor. If the engine turns but

fails to start after several attempts, there may be other technical problems with the vehicle. Stop

cranking the engine until other possible problems are determined and corrected.

If the vehicle starts, turn the jump starter OFF. Disconnect the black negative clamp first and then the red

positive clamp. Place the clamps back in to the storage recesses on the jump starter.

USING THE AIR COMPRESSOR

WARNING:

Check item to be inflated for manufacturer's maximum recommended inflation pressure. Avoid over inflation.

Most tyres are fully inflated between 24-35 PSI. Some truck and bicycle tyres could require 40 PSI or more.

Open compartment door at the back of the jump starter and pull out the air hose. Make sure the nozzle

lever is in the UP position.

Attach the valve adaptor to the valve stem of the tyre and push the valve adaptor lever down to lock it

into place.

Turn the compressor power switch to the ON position

Monitor the pressure gauge whilst inflating, do not exceed the recommended pressure for the tyre/device

you are inflating. It is recommended that you use a separate air gauge to check the actual inflation pressure

for accuracy. When the desired pressure level is reached, turn off the compressor, turn the valve adaptor

lever to the up position and remove the adaptor from the valve stem and disconnect the hose.

When using the air compressor, you must wait a minimum of 10 minutes before inflating the next

tyre / item.

Note: Prior to connecting an accessory, make sure that the USB port On/Off power switch is in the OFF position.

Accessory Connection (MP3 Players, Mobile Phone, etc.)

Remove the protective cover of the USB outlet on the jump starter. Connect the USB interface cable

(provided with the accessory)

Press the USB Port On/Off switch to the ON position. Turn on the accessory.

Important: The 12 volt DC power port is rated at 10 Amp. DO NOT connect device(s) that require higher

amperage to operate. This device(s) will cause the internal circuit breaker to open.

Remove the protective cover from the 12 volt DC accessory socket.

Plug in your 12 volt accessory.

The length of time for which a connected device can be powered will depend on the battery charge status

of your jump starter and also the amount of current required by the device which you are powering.

Turn the work light power switch to the ON position.

The 3 x LED will illuminate.

Turn OFF when not in use.